Motorola Edge 40 Pro leaked renders reveal triple rear cameras, water resistance, and more

In a tweet by reputed tipster Evan Blass, the Motorola Edge 40 Pro renders have finally been leaked. As expected before an impending launch, the design renders of the smartphone are out. For starters, you get a seamless front display design with a tiny punch-hole selfie camera and minimal bezels.

Then, certain images of the Motorola Edge 40 Pro’s back panel reveal a triple camera setup with a flash at the back. And, the branding also reveals that the primary sensor will be a large, 50MP one. Other than that, on the back, you see the Motorola branding and nothing else. One render where the smartphone is shown dipped in water suggests it could come with a decent water resistance rating, probably IP67 or IP68.

But, the biggest giveaway, which has been seen in previous leaks as well, is that the Edge 40 Pro looks too much like the Moto X40. This goes on to show that the upcoming Motorola Edge 40 Pro could indeed be the internationally rebranded version of the X40. 

Motorola Edge 40 Pro specifications

If the Motorola Edge 40 Pro is indeed a rebrand of the Moto X40, then we should expect specifications like a 6.7-inch fHD+ AMOLED panel with a 165Hz refresh rate, a Snapdragon 8 Gen 2 processor, 12GB of RAM, 512GB of internal storage, a 60MP selfie camera, and a 4600mAh battery with 125W fast wired and 15W wireless charging support.

To recall, the Motorola Edge 40 Pro was spotted on Geekbench last month with a similar set of internal specifications. The listing confirmed the presence of a top-end octa-core processor and 12GB of RAM. As for benchmark scores, the phone did manage to do well with 1480 in the single-core round and 4889 points in the multi-core segment, putting it on par with most Android flagships out there.